To cycle between low & high voltage disconnect and reconnect the cartridge 3 times. A blue light = low voltage mode = colder atomizer temperature. A white light = high voltage mode = hotter atomizer temperature.

To enter Pre-Heat mode disconnect and reconnect the cartridge 2 times. The light should turn green when in Pre-Heat mode. Pre-Heat mode will stay on for 5 seconds and turn off automatically.

This device is equipped with an 8 second draw limiter. After 8 seconds of continuous inhalation the light will blink and the device will shut off automatically.

If the light turns red during inhalation, the device has less than 10% battery left. Please charge the battery as soon as possible.

To charge with a cable, use the included usb cable. A glowing red light indicates the device is charging.

Although our cartridges are equiped with dual air channels to mitigate clogging, in rare occurences it can happen. In the event you draw on the cartridge, the light turns on, but no vapor comes out, most likely the vapor channel is clogged with residual oil. Use a paper clip to gently remove or clear the clog.